16-24 Camaro SS 6.2L 5" Cold Air Intake - JLT Performance

FITS 2016-2024 CAMARO ( SS MODELS )[ REQUIRES TUNING ] 
Installation Instructions

DESCRIPTION:

LT’s New Cold Air Intake kits for the 2016-2024 Camaro SS in textured black plastic finish. Designed to make huge power this new kit has a large 120mm ID through out the tube, with a 5” bell mouth at the MAF. This huge 5” opening requires a huge filter. We love the tapered flange design and Powerstack filtered ends of S&B's filters and ended up with a monster 5x7” filter. With deep pleats, you don’t get much better than this. Finish it off with a silicone reducer and stainless clamps and you got the BEST Intake on the market!!! NO METAL TUBING HERE!!

KEY FEATURES:

• MOLDED-IN MAF It’s a full 120mm ID at the MAF area
• HEATSHIELD Includes ABS plastic heat shield to block engine heat at idle and low speed. It incorporates the fresh air inlet from the grill. It uses a large area to make sure the filter has tons of cool air.

• GAINS AND TESTING 

  Up to up to 25 RWHP & RWTQ “peak” gains, but as high as 36 RWHP and RWTQ have been seen through out the RPM range when used with our custom tune!

• Tuning 

  A JLT Specific Tune is required with this kit

IMPORTANT NOTES:

• This product is NOT CARB (California Air Resource Board) Exempt. It is not for legal sale or use in the state of CA or any other states adopting CA emission standards and requires a CA Executive Order (EO) number. Any orders placed for this item with a CA ship to address will be canceled.

INCLUDES:

• JLT Black Textured Plastic Intake Tube
• Silicone Reducer
• 5x7 S&B powerstack Air Filter
• ABS Heat Shield
• HD Clamps, & all needed hardware 

PRODUCT VIDEO:

About JLT:

JLT Performance began in 2003 when the founder, Jay Tucker, became frustrated at trying to find a good cold air intake for a 1999 Saleen Mustang that was one of his project cars. After being frustrated with other vendors, he just sat down and built his own cold air intake. It worked beautifully on that 1999 Saleen Mustang, and JLT Performance's story began. Tucker's next project car was a 2003 Mustang Cobra, and another JLT Performance cold air intake was created. This time, Tucker posted pictures and results on Mustang forums and received an overwhelming response. Thinking that if he sold more of his first JLT Performance cold air intakes he could turn the profits around and invest them back into the Cobra, he got busy making his first cold air intakes as the business got its start.