16-18 Camaro Reverse Lamp LED Harness - Gen5DIY

Write a Review

Fits 2016-2018 Camaro Models, Looking to add Reverse LED Bulbs

 When adding LED reverse bulbs to your 2016-2018 Gen6 camaro, you will need to add a load resistor to prevent the LED bulb from staying illuminated when not in reverse.  This plug and play harness is a simple solution to that "run on problem".  This harness is plug and play and does come with the needed resistor.  You can use your own LED bulbs or we have them available as an option.   In the picture the LED bulb is installed on driver's side taillight.  This harness works on all Gen6 Camaro's including those without the "RS" package. 1 harness needed per vehicle
New design only requires 1 resistor..


This kit is a simple installation and is 100% plug and play. It requires you to remove the plastic shroud above the rear tail lamp (on either side, does not matter), and will plug in between the tail lamp harness and the rear lamp wiring harness off of the body. 
It will only be one harness, and as mentioned before, can be installed on either side, tail lamp assembly. 

8.00 (in)
6.00 (in)
6.00 (in)